Series V626 | Dur A Pell GS

Generic Type RTV Silicone Rubber Water Repellent and Graffiti Protectant
Common Usage Series 626 Dur A Pell GS has been formulated to provide superior protection against, and easy removal of, unwanted graffiti. This product is intended for use in conjunction with Series 680 Mark A Way to provide a complete Graffiti Protection System. Dur A Pell GS is a clear, silicone rubber based formulation, which protects vertical concrete block, brick, cast concrete, stone and other masonry substrates with little or no change to the appearance of the untreated substrate. Dur A Pell GS protects both new and existing substrates by penetrating into the pores, to prevent graffiti penetration. It has excellent stability against ultraviolet rays and salt spray and provides long-lasting protection. Note: Series V626 conforms with air pollution regulations limiting Volatile Organic Compounds (VOC) to a maximum of 100 grams/litre (0.83 lbs/gallon).
Colors Clear
Finish Flat to slight sheen, depending on substrate.
Primers Apply directly to uncoated concrete and masonry substrates.
Volume Solids 15%
Recommended DFT Penetrating coating system, no DFT recommended. Two flood coats required for graffiti protection. One coat for water repellent applications.
Curing Time
TemperatureTo TouchTo RecoatInitial CureFull Cure
75°F (24°C)2 hours30 minutes to 2 hours6-12 hours for Moisture Intrusion24 hours for Moisture Intrusion, 5 days for Graffiti Protection

Curing time varies with surface temperature, substrate porosity, air movement, humidity and application rate.
Volatile Organic Compounds 626: 5.49 lbs/gallon (658 grams/litre)
V626: 0.81 lbs/gallon (97 grams/litre)
Number of Components One

The products listed below are not exact equivalents. They are only products that you may consider as alternatives in a general sense. Substrate type, condition, temperatures, surface preparation, primer/topcoat selection and intended use are just a few factors that will affect product selection. Please contact your local Tnemec Coatings Consultant for product recommendations.

This ProductRTV Silicone Rubber Water Repellent and Graffiti Protectant
Volume SolidsRec. DFTV.O.C.# of Components
15%Penetrating coating system, no DFT recommended. Two flood coats required for graffiti protection. One coat for water repellent applications.626: 5.49 lbs/gallon (658 grams/litre)
V626: 0.81 lbs/gallon (97 grams/litre)
One
Series 626 | Dur A Pell GS RTV Silicone Rubber Water Repellent and Graffiti Protectant
Hide this product's data
Volume SolidsRec. DFTV.O.C.# of Components
15%Penetrating coating system, no DFT recommended. Two flood coats required for graffiti protection. One coat for water repellent applications.626: 5.49 lbs/gallon (658 grams/litre)
V626: 0.81 lbs/gallon (97 grams/litre)
One

Series 626 Dur A Pell applied to brick building exterior.